Im dying because one of my final task I dont know where I should open this thread but I think this is the best place Does anyone of you know how to separate MR (music recorded) and vocal also known as nude mp3?? it's the same to decrease or increase the MR..but I dont know how.. also i what software i should use.?
i know you have to apply the sound file through a filter which will nullify the treble portion.... but which program does it im not sure anymore..
thank you for your explanation im not asking about which one is the best..just wanna know what software u use??
You are never going to get a perfect extraction. Read more here. Many have tried, many have failed http://www.adobeforums.com/webx/.2cccbe9d
kinda like that..my teacher aksed me to make a film..i need the music only from the song because the vocal is too loud than the music..its essential but really important sorry for aking ths again..what software u usually use??
Sorry, I don't have a solution for you. I only asked the question because at one time, I was trying to do the same thing and didn't find a decent solution. What is the name of the music you are using? Perhaps we can help you find an instrumental version.
so you just want to mooosic...and not the vocals..??... my friends use adobe audition and then vocal remove....i dunno how ya do it.....but thas how they normally tell me... good luck~~~~!
Dude, Gosh you have alot at hand given your task... Its better to find parts of the track without vocals and then try to assemble it with Adobe Audition. So far, Audition does the job best... Else you have to isolate the frequency of the vocals and notch that down, but that would never really solve the problem.. Your best bet is as follow. 1. Use Adobe Audtion's Vocal Cut presets. 2. Try to isolate the vocals to see if it is more to the right, or left of the track 3. After using vocal cut. Mix down the L and R track again to give you the balance. 4. Notch out the Mids levels frequency. You might hear "squigles" in some portion where the vocals have been cut. 5. Next, Fatten the bass and the Highs to try your best to mask the "squigles". My suggestion, get the music scores and then get it played in a music syn and then proceed to enrich the track with the ORIGINAL soundtrack where the vocals are not present. Sometimes, a solo guitar track of the track might work really well but that depends on the kind of mood you want to set for the piece of film you are making. All the best
it is local music..it'll hard to find the instrumental version -doh is it different?? there's one song that i want to take the vocal and there're songs that i want to remove the music.. thank you for your explanation..it's really helpful
Try audacity http://audacity.sourceforge.net/ and this wiki http://audacityteam.org/wiki/index.php?title=Vocal_Removal
